Bolt pattern | stud pattern

MITSUBISHI Bolt Patterns

Here you will find MITSUBISHI bolt patterns or stud patterns.

MODEL YEAR O.E. WHEEL SIZE BOLT PATTERN STUD SIZE HUB/CENTER BORE OFFSET
CORDIA, TREDIA 83-88 13×5.5 4×114.3 12×1.5 67.1 H
CORDIA, TREDIA 86-88 14×5.5 4×114.3 12×1.5 67.1 H
DIAMANTE 91- 15×6 5×114.3 12×1.5 67.1 H
ECLIPSE 89-UP 14″-20″ 5×114.3 12×1.5 67.1 H
EXPO 91-95 14×6 4×114.3 12×1.5 67.1 H
GALANT 85-96 14×5.5 4×114.3 12×1.5 67.1 H
GALANT 97- 15×6 5×114.3 12×1.5 67.1 H
LANCER LS 15″ 02-   4×114.3 12×1.5 67.1 H
LANCER LS 14″ 02-   4×100 12×1.5 67.1 H
LANCER EVOLUTION 04- 15×6 5×114.3 12×1.5 67.1 H
MIRAGE3 85-92 13×5.5 4×114.3 12×1.5 67.1 H
MIRAGE 93- 14×5.5 4×100 12×1.5 56.1 H
PRECIS3 83-93 13×5.5 4×114.3 12×1.5 67.1 H
STARION 83-87 14×6 4×114.3 12×1.5 67.1 H
STARION, TURBO 86-89 16×7,8 5×114.3 12×1.5 67.1 M
3000, GT, SL 91-96 16×8 5×114.3 12×1.5 67.1 H
3000 GT VR4 91-97 17×8.5 5×114.3 12×1.5 67.1 M
MONTERO 83-00 15×6 6×139.7 12×1.5 108 L/M
MONTERO 01- 15X6 6×139.7 12×1.5 67.1 L/M
MONTERO SPORT 92- 15×6 6×139.7 12×1.5 108 M
OUTLANDER 03-   5×114.3 12×1.5 67.1 M/H
PICKUP 83-96 14×6 6×139.7 12×1.5 108 L/M
VAN/WAGON 87-90 14×5.5 5×114.3 12×1.5 67.1 H

At wheelsupport.com , you will fine lots of info about your wheels , rims .
You will fine bolt pattern. you will find stud pattern. you will find information about the wheels and rims on your car.
you can also find the information about your lug nuts, CB ( Center Bore ) or Center hole and offset of your rim. Most rims are interchangeable from one car to another car.
To find out you need to compare your bolt pattern with the bolt pattern of the wheel you have on hand. Sometimes its difficult to find out about the specific information about the rims if you only have the wheels but no stud or bold pattern information . i used to take my rim to a junk yard and try one on a different wheel hub with off course with calipers on the rims. Then i recorded the make, model and year of the car and was looking for the wheel information about that rims. That way i was finding my car's bold pattern. Now I am quite used to recognizing the stud pattern. Its my eyes that do the magic. i can easily tell if a rim will fit a car or not.
Its a couple factor that really decide if a rim will fit into a car.


Bold pattern | Stud pattern :
Used to describe the amount of lugs your car, or wheels, have, and also the measurement in between them.
For example, 5x4.5 This would be 5 lugs, spaced 4.5" across.
Also measure in mm, for example 5x114.3. 5 lugs, spaced 114.3 mm apart. 5x4.5 = 5x114.3


CB (Center Bore or Center Hole ) :
The centerbore of a wheel is the size of the hole in the back of the wheel that centers it over the mounting hub of the car.
Some factory wheels have a centerbore that matches exactly with the hub to reduce vibration by keeping the wheel centered. Wheels with the correct centerbore to the car they will be mounted on are known as hubcentric. Hubcentric wheels take the stress off the lug nuts, reducing the job of the lug nuts to center the wheel to the car.
Wheels that are not hubcentric are known as lugcentric, as the job of centering is done by the lug nuts assuming they are properly torqued down. Centerbore on aftermarket wheels must be equal to or greater than that of the hub, otherwise the wheel cannot be mounted on the car.
Many aftermarket wheels come with "hubcentric rings" that lock or slide into the back of the wheel to adapt a wheel with a larger centerbore to a smaller hub.[3] These adapters are usually made of plastic but also in aluminum. (Courtesy of Wikipedia)


Offset :
Offset is the measurement of where the mounting surface of the wheel is (where the bolt holes are), compared to the centerline of the wheel. Usually referred to as negative, positive, or zero offset or Low, Medium or High. other property of the wheels are also effective in deciding to purchase a rim for your car but basically i found the above properties most important.
Leave a Reply

You must be logged in to post a comment.

Copyright © 2011 Bolt pattern | stud pattern